blob: 75b901a86bb0754a596ac15de918e1ccd36f45a4 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
|
========================================================================
UHD - USRP-B1XX Series Application Notes
========================================================================
.. contents:: Table of Contents
------------------------------------------------------------------------
Specify a non-standard image
------------------------------------------------------------------------
The UHD will automatically select the USRP B-Series images from the installed images package.
The image selection can be overridden with the "fpga" and "fw" device address parameters.
Example device address string representations to specify non-standard images:
::
fpga=usrp_b100_fpga_firmware.bin
-- OR --
fw=usrp_b100_fw_firmware.ihx
------------------------------------------------------------------------
Changing the master clock rate
------------------------------------------------------------------------
The master clock rate of the USRP embedded feeds both the FPGA DSP and the codec chip.
Hundreds of rates between 32MHz and 64MHz are available.
A few notable rates are:
* 64MHz - maximum rate of the codec chip
* 61.44MHz - good for UMTS/WCDMA applications
* 52Mhz - good for GSM applications
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Set 61.44MHz - uses external VCXO
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
To use the 61.44MHz clock rate, the USRP embedded will require two jumpers to be moved.
* J16 is a two pin header, remove the jumper (or leave it on pin1 only)
* J15 is a three pin header, move the jumper to (pin1, pin2)
**Note:** See instructions below to communicate the desired clock rate into the UHD.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Set other rates - uses internal VCO
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
To use other clock rates, the jumpers will need to be in the default position.
* J16 is a two pin header, move the jumper to (pin1, pin2)
* J15 is a three pin header, move the jumper to (pin2, pin3)
To communicate the desired clock rate into the UHD,
specify the a special device address argument,
where the key is "master_clock_rate" and the value is a rate in Hz.
Example:
::
uhd_usrp_probe --args="master_clock_rate=52e6"
|
