Merge branch 'u1e' into merge_u1e

* u1e: (130 commits)
  invert led signals because they are active low
  duh
  allow for CS to rise before, at the same time, or after OE
  better debug pins
  watch the ethernet chip select on our debug bus
  fix timing issue on DAC outputs with rev 2.  This puts the whole system on a 90 degree phase shift
  send all gpmc signals to mictor
  updated pins to match rev2, removed dip switch, etc.  seems to compile ok.
  pins are different on rev2
  fixed makefile to compile with our new system
  add register to tell host about compatibility level and which image we are using
  move declaration to make loopback compile
  no need for protocol headers since we're not doing ethernet
  match the signal names in this design
  debug pins cleanup
  properly integrate the new tx chain
  catch up with tx_policy
  attach run_tx and run_rx to leds
  connect atr
  delay the q channel to make the channels line up on the AD9862
  ...

Conflicts:
	usrp2/control_lib/Makefile.srcs

1 files changed, 0 insertions, 40 deletions

diff --git a/usrp2/fifo/fifo36_to_fifo18.v b/usrp2/fifo/fifo36_to_fifo18.v
deleted file mode 100644
index b636ab9ca..000000000
--- a/usrp2/fifo/fifo36_to_fifo18.v
+++ /dev/null
@@ -1,40 +0,0 @@
-
-module fifo36_to_fifo18
-  (input clk, input reset, input clear,
-   input [35:0] f36_datain,
-   input f36_src_rdy_i,
-   output f36_dst_rdy_o,
-   
-   output [17:0] f18_dataout,
-   output f18_src_rdy_o,
-   input f18_dst_rdy_i );
-
-   wire   f36_sof  = f36_datain[32];
-   wire   f36_eof  = f36_datain[33];
-   wire   f36_occ  = f36_datain[35:34];
-
-   reg phase;
-
-   wire half_line 	   = f36_eof & ((f36_occ==1)|(f36_occ==2));
-   
-   assign f18_dataout[15:0] = phase ? f36_datain[15:0] : f36_datain[31:16];
-   assign f18_dataout[16]  = phase ? 0 : f36_sof;
-   assign f18_dataout[17]  = phase ? f36_eof : half_line;
-   
-   assign f18_src_rdy_o    = f36_src_rdy_i;
-   assign f36_dst_rdy_o    = (phase | half_line) & f18_dst_rdy_i;
-	
-   wire f18_xfer 	   = f18_src_rdy_o & f18_dst_rdy_i;
-   wire f36_xfer 	   = f36_src_rdy_i & f36_dst_rdy_o;
-
-   always @(posedge clk)
-     if(reset)
-       phase 		  <= 0;
-     else if(f36_xfer)
-       phase 		  <= 0;
-     else if(f18_xfer)
-       phase 		  <= 1;
-   
-       
-endmodule // fifo36_to_fifo18
-