blob: 538d60fce7a07d0b90c9eb16e54b55eb35512e6a (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
|
========================================================================
UHD - USRP-B1XX Series Application Notes
========================================================================
.. contents:: Table of Contents
------------------------------------------------------------------------
Specify a non-standard image
------------------------------------------------------------------------
The UHD will automatically select the USRP B-Series images from the installed images package.
The image selection can be overridden with the "fpga" and "fw" device address parameters.
Example device address string representations to specify non-standard images:
::
fpga=usrp_b100_fpga_firmware.bin
-- OR --
fw=usrp_b100_fw_firmware.ihx
------------------------------------------------------------------------
Changing the master clock rate
------------------------------------------------------------------------
The master clock rate of the USRP embedded feeds both the FPGA DSP and the codec chip.
Hundreds of rates between 32MHz and 64MHz are available.
A few notable rates are:
* 64MHz - maximum rate of the codec chip
* 61.44MHz - good for UMTS/WCDMA applications
* 52Mhz - good for GSM applications
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Set 61.44MHz - uses external VCXO
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
To use the 61.44MHz clock rate, the USRP embedded will require one jumper to be moved,
and X4 must be populated with a 61.44 MHz oscillator.
* **J15** is a three pin header, move the jumper to (pin1, pin2)
* **357LB3I061M4400** is the recommended oscillator for X4
**Note:** See instructions below to communicate the desired clock rate into the UHD.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Set other rates - uses internal VCO
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
To use other clock rates, the jumper will need to be in the default position.
* **J15** is a three pin header, move the jumper to (pin2, pin3)
To communicate the desired clock rate into the UHD,
specify the a special device address argument,
where the key is "master_clock_rate" and the value is a rate in Hz.
Example:
::
uhd_usrp_probe --args="master_clock_rate=52e6"
------------------------------------------------------------------------
Hardware setup notes
------------------------------------------------------------------------
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Front panel LEDs
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
The LEDs on the front panel can be useful in debugging hardware and software issues.
The LEDs reveal the following about the state of the device:
* **LED A:** transmitting
* **LED B:** fpga loaded
* **LED C:** receiving
* **LED D:** fpga loaded
* **LED E:** reference lock
* **LED F:** board power
------------------------------------------------------------------------
Miscellaneous
------------------------------------------------------------------------
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Available Sensors
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
The following sensors are available;
they can be queried through the API.
* ref_locked - clock reference locked (internal/external)
|
