uhd - Ettus' UHD Repository

	Commit message (Collapse)	Author	Age	Files	Lines
*	u1p: use 18 bit fifos and use full size of a block ram in the tx path	Matt Ettus	2011-05-26	2	-13/+19
\|
*	u1p: gpif-to-fx2 path should now handle arbitrary sized packets, up to 2KB	Matt Ettus	2011-05-26	1	-22/+29
\|
*	u1p: pass tx status/error packets back through GPIF over the response ↵	Matt Ettus	2011-05-26	5	-18/+106
\| \| \| \|	channel (short packets)
*	u1p: added loopback and timed capability just like u1e	Matt Ettus	2011-05-26	3	-28/+111
\|
*	u1p: revert change to address bus width	Matt Ettus	2011-05-26	1	-2/+2
\|
*	u1p: use icarus verilog to find warnings	Matt Ettus	2011-05-26	2	-0/+4577
\|
*	u1p: fix bus widths and other warnings	Matt Ettus	2011-05-26	5	-52/+53
\|
*	u1p: added debug0, debug1 for GPIF debugging	Nick Foster	2011-05-26	1	-0/+3
\|
*	u1p: add clear ports to gpif, not hooked up yet	Matt Ettus	2011-05-26	1	-1/+1
\|
*	u1p: remove extram from Makefile	Nick Foster	2011-05-26	1	-1/+0
\|
*	u1p: catch up with all the recent u1e changes	Matt Ettus	2011-05-26	1	-107/+91
\|
*	modernize the make files, it now compiles. not tested.	Matt Ettus	2011-05-26	2	-56/+10
\|
*	select bus is 2 bits wide	Nick Foster	2011-05-26	1	-1/+1
\|
*	I2C slave address decoding for 16-bit dw instead of 32-bit	Nick Foster	2011-05-26	1	-1/+1
\|
*	Fixed I2C pin names.	Nick Foster	2011-05-26	1	-1/+1
\|
*	add padding into gpif response path	Matt Ettus	2011-05-26	3	-4/+16
\|
*	pad out packets to a minimum length	Matt Ettus	2011-05-26	2	-1/+76
\|
*	fixed length command packets	Matt Ettus	2011-05-26	1	-1/+1
\|
*	give response packets the same format as tx packets	Matt Ettus	2011-05-26	1	-1/+13
\|
*	successful test	Matt Ettus	2011-05-26	1	-0/+104
\|
*	old and unused	Matt Ettus	2011-05-26	1	-151/+0
\|
*	put gpio back in	Matt Ettus	2011-05-26	1	-4/+3
\|
*	fifo to wb should be functionally complete, needs testing	Matt Ettus	2011-05-26	3	-34/+150
\|
*	not used	Matt Ettus	2011-05-26	1	-16/+0
\|
*	fix ctrl/resp path to pass all 16 bits of data instead of the bottom bit	Matt Ettus	2011-05-26	3	-38/+47
\| \| \| \| \|	typos fixed, everything is connected now, should just have off-by-1 error lots of debug pins added
*	send reset to the gpif	Matt Ettus	2011-05-26	1	-2/+3
\|
*	constrain the gpif clock	Matt Ettus	2011-05-26	1	-0/+3
\|
*	first steps to a command packet handler for u1+	Matt Ettus	2011-05-26	2	-0/+17
\|
*	redone gpif interface to match nick's new spec	Matt Ettus	2011-05-26	4	-62/+125
\|
*	use vita_tx_chain top level block	Matt Ettus	2011-05-26	1	-22/+14
\|
*	hook up flow control pins	Matt Ettus	2011-05-26	1	-2/+10
\|
*	added a loopback control port, will do full wishbone interface later	Matt Ettus	2011-05-26	3	-7/+50
\|
*	progress on gpif interface	Matt Ettus	2011-05-26	4	-110/+119
\|
*	gpif skeletons	Matt Ettus	2011-05-26	7	-134/+111
\|
*	skeleton	Matt Ettus	2011-05-26	1	-0/+122
\|
*	copied over from u1e, most pins hooked up.	Matt Ettus	2011-05-26	6	-637/+588
\|
*	Use the 4th LED which is shared on the cfg_init_b pin	Matt Ettus	2011-05-26	2	-6/+10
\|
*	compiles now	Matt Ettus	2011-05-26	4	-643/+185
\|
*	copied over from other repo. Beginnings of a skeleton fpga image for USRP1-Plus	Matt Ettus	2011-05-26	11	-0/+1854
\|
*	u1e: incremented compat # to 4 for vita length change	Josh Blum	2011-05-20	1	-1/+1
\|
*	N210: how the heck did the PPS fix get dropped again	Nick Foster	2011-05-20	1	-1/+4
\|
*	u1e: get dsp_framer36 from u1p so it can skip the protocol header	Matt Ettus	2011-05-09	4	-10/+100
\|
*	u1e: switch to vita_rx_chain module just like other toplevels	Matt Ettus	2011-05-09	2	-20/+11
\|
*	N210: Bootloader includes TXRX. No longer uses safe firmware as backup fw.	Nick Foster	2011-04-22	1	-368/+368
\|
*	N210: Make new bootloader ignore safe firmware when safe mode button is pushed.	Nick Foster	2011-04-21	1	-331/+331
\|
*	N210: bootram expanded to 16KB (8 BRAMs) and UDP bootloader added	Nick Foster	2011-04-21	2	-496/+541
\|
*	N210: UDP bootloader first stab (16K boot RAM)	Nick Foster	2011-04-21	2	-172/+428
\|
*	Merge branch 'master' into next	Matt Ettus	2011-03-27	10	-34/+120
\|\ \| \| \| \| \| \| \| \| \| \| \| \|	* master: u2p: N200 Makefile u1e: use icarus verilog for lint clean up a bunch of warnings and incorrect bus widths
\| *	u2p: N200 Makefile	Matt Ettus	2011-03-23	1	-0/+98
\| \|
\| *	u1e: use icarus verilog for lint	Matt Ettus	2011-03-16	1	-0/+2
\| \|