| Commit message (Expand) | Author | Age | Files | Lines |
|---|
| * | E100: GPSDO serial port level conversion | Nick Foster | 2011-09-28 | 2 | -2/+9 |
| * | B100: use gpif_misc on R2 hw, invert direction of gpif_misc pins | Nick Foster | 2011-09-19 | 1 | -2/+2 |
| * | u1e,u1p: turn off debug pins, misc cleanups | Matt Ettus | 2011-09-08 | 2 | -26/+10 |
| * | u1p: proper format in ucf file | Matt Ettus | 2011-09-08 | 5 | -4/+474 |
| * | u1e: relax GPMC constraints, eases P&R | Matt Ettus | 2011-09-02 | 1 | -10/+10 |
| * | u1e: separate build for E100 and E110, just a different FPGA | Matt Ettus | 2011-09-01 | 2 | -1/+102 |
| * | e100: squashed work on bus implementation on GPMC | Josh Blum | 2011-08-29 | 22 | -984/+545 |
| * | fix warning on dat_o in atr_controller16.v | Josh Blum | 2011-08-29 | 1 | -3/+2 |
| * | fpga: minor tweaks to build system | Josh Blum | 2011-08-26 | 2 | -2/+4 |
| * | fix typo | Matt Ettus | 2011-08-26 | 1 | -21/+21 |
| * | all: tie unused ram inputs to 1 instead of zero, helps routing | Matt Ettus | 2011-08-26 | 2 | -22/+22 |
| * | b100: gpif_rst resynced to gpif_clk | Matt Ettus | 2011-08-26 | 1 | -1/+1 |
| * | dsp: slow down the time constant of the DC offset correction by a factor of 1... | Matt Ettus | 2011-08-26 | 1 | -1/+1 |
| * | usrp2: reconnect frontend calibration, timing meets | Josh Blum | 2011-08-26 | 5 | -6/+6 |
| * | e100: continuation of the atr fix to get e100 to build | Josh Blum | 2011-08-15 | 1 | -2/+2 |
| * | usrp2: bump FPGA minor number to 2 for patch release | Josh Blum | 2011-08-15 | 2 | -2/+2 |
| * | connect unused BRAM inputs to 1s to save routing logic | Josh Blum | 2011-08-15 | 1 | -1/+1 |
| * | dsp: clear cic_decim when not enabled | Matt Ettus | 2011-08-15 | 1 | -4/+4 |
| * | N2x0: print constraints summary from makefile | Josh Blum | 2011-08-15 | 1 | -0/+1 |
| * | N2x0: added a Makefile to build all N2x0 projects (make -j4) | Josh Blum | 2011-08-15 | 1 | -0/+22 |
| * | N2x0: delay ADC A inversion so A and B are latched in the same | Josh Blum | 2011-08-15 | 1 | -3/+5 |
| * | B100/E100: fix ATR RX mode pins not connected | Nick Foster | 2011-08-10 | 2 | -4/+4 |
| * | time: register time output to help fpga timing | Matt Ettus | 2011-07-28 | 1 | -2/+5 |
| * | vrt: delay the late signal to help with timing | Matt Ettus | 2011-07-28 | 1 | -5/+20 |
| * | dsp: allow tx iq balance to be removed at compile time | Matt Ettus | 2011-07-28 | 1 | -23/+38 |
| * | dsp: option to remove iq compensation at compile time | Matt Ettus | 2011-07-28 | 1 | -35/+40 |
| * | time64: reverted mimo sync changes to time64 | Josh Blum | 2011-07-28 | 1 | -3/+1 |
| * | u2/u2p: speed up time_64, and remove readbacks on simple_gemac wb regs | Matt Ettus | 2011-07-28 | 2 | -11/+13 |
| * | simple_gemac: remove old 19-bit wide wrapper | Matt Ettus | 2011-07-28 | 4 | -402/+0 |
| * | usrp2: remove old unused readback mux value | Josh Blum | 2011-07-28 | 2 | -2/+2 |
| * | usrp2: bump minor version number for changes | Josh Blum | 2011-07-28 | 2 | -2/+2 |
| * | vita_rx_ctrl: use an extra cmd bit to signal stop | Josh Blum | 2011-07-28 | 1 | -7/+7 |
| * | usrp2: fixed swapped tx/rx signals for nsgpio | Josh Blum | 2011-07-28 | 2 | -2/+2 |
| * | simple_gemac: add parameter to allow disabling rx flow control at compile time | Matt Ettus | 2011-07-27 | 1 | -6/+10 |
| * | u2/u2p: apply atr/gpio changes to u2p | Matt Ettus | 2011-07-27 | 2 | -14/+7 |
| * | atr: forgot to delete this line | Matt Ettus | 2011-07-27 | 1 | -1/+0 |
| * | u2: redo the atr gpio pins, remove some old cruft | Matt Ettus | 2011-07-27 | 2 | -52/+48 |
| * | u2p: finish copying over serdes light fix | Matt Ettus | 2011-07-22 | 1 | -2/+1 |
| * | u2/u2p: further qualify the serdes link light | Matt Ettus | 2011-07-21 | 3 | -7/+13 |
| * | usrp2: split inspection logic into each relevant cycle | Josh Blum | 2011-07-19 | 1 | -11/+35 |
| * | appease the ISE gods | Matt Ettus | 2011-07-19 | 5 | -2/+5 |
| * | removed wb readback of ATR, allowing it to be synthesized as luts | Matt Ettus | 2011-07-19 | 2 | -4/+10 |
| * | N200: detailed map report allows you to see what takes up too much space | Matt Ettus | 2011-07-19 | 4 | -0/+4 |
| * | dsp: reduce bitwidth to help timing | Matt Ettus | 2011-07-19 | 1 | -4/+6 |
| * | fpga: print timing report after generate bin file | Josh Blum | 2011-07-19 | 2 | -1/+34 |
| * | dsp: reset the interpolator when the rate changes, to prevent oscillation | Matt Ettus | 2011-07-19 | 1 | -7/+8 |
| * | b100: fix for fpga syntax error on xfer_rate | Josh Blum | 2011-07-19 | 1 | -1/+1 |
| * | Merge branch 'b100_shrink' into new_work | Josh Blum | 2011-07-19 | 29 | -718/+967 |
| |\ |
|
| | * | usrp2: split compat number into major/minor (increment minor for fixes) | Josh Blum | 2011-07-03 | 2 | -2/+2 |
| | * | e100: proc_int should be high when interrupted | Josh Blum | 2011-06-20 | 1 | -3/+1 |
