Commit message (Collapse) | Author | Age | Files | Lines | |
---|---|---|---|---|---|
* | u1p: fix bus widths and other warnings | Matt Ettus | 2011-05-26 | 1 | -9/+10 |
| | |||||
* | u1p: added debug0, debug1 for GPIF debugging | Nick Foster | 2011-05-26 | 1 | -0/+3 |
| | |||||
* | u1p: remove extram from Makefile | Nick Foster | 2011-05-26 | 1 | -1/+0 |
| | |||||
* | u1p: catch up with all the recent u1e changes | Matt Ettus | 2011-05-26 | 1 | -107/+91 |
| | |||||
* | modernize the make files, it now compiles. not tested. | Matt Ettus | 2011-05-26 | 1 | -56/+9 |
| | |||||
* | I2C slave address decoding for 16-bit dw instead of 32-bit | Nick Foster | 2011-05-26 | 1 | -1/+1 |
| | |||||
* | Fixed I2C pin names. | Nick Foster | 2011-05-26 | 1 | -1/+1 |
| | |||||
* | put gpio back in | Matt Ettus | 2011-05-26 | 1 | -4/+3 |
| | |||||
* | send reset to the gpif | Matt Ettus | 2011-05-26 | 1 | -2/+3 |
| | |||||
* | constrain the gpif clock | Matt Ettus | 2011-05-26 | 1 | -0/+3 |
| | |||||
* | redone gpif interface to match nick's new spec | Matt Ettus | 2011-05-26 | 1 | -2/+2 |
| | |||||
* | use vita_tx_chain top level block | Matt Ettus | 2011-05-26 | 1 | -22/+14 |
| | |||||
* | added a loopback control port, will do full wishbone interface later | Matt Ettus | 2011-05-26 | 1 | -6/+8 |
| | |||||
* | progress on gpif interface | Matt Ettus | 2011-05-26 | 1 | -9/+1 |
| | |||||
* | gpif skeletons | Matt Ettus | 2011-05-26 | 3 | -134/+31 |
| | |||||
* | copied over from u1e, most pins hooked up. | Matt Ettus | 2011-05-26 | 6 | -637/+588 |
| | |||||
* | Use the 4th LED which is shared on the cfg_init_b pin | Matt Ettus | 2011-05-26 | 2 | -6/+10 |
| | |||||
* | compiles now | Matt Ettus | 2011-05-26 | 4 | -643/+185 |
| | |||||
* | copied over from other repo. Beginnings of a skeleton fpga image for USRP1-Plus | Matt Ettus | 2011-05-26 | 11 | -0/+1854 |
| | |||||
* | u1e: incremented compat # to 4 for vita length change | Josh Blum | 2011-05-20 | 1 | -1/+1 |
| | |||||
* | N210: how the heck did the PPS fix get dropped again | Nick Foster | 2011-05-20 | 1 | -1/+4 |
| | |||||
* | u1e: get dsp_framer36 from u1p so it can skip the protocol header | Matt Ettus | 2011-05-09 | 1 | -1/+1 |
| | |||||
* | u1e: switch to vita_rx_chain module just like other toplevels | Matt Ettus | 2011-05-09 | 2 | -20/+11 |
| | |||||
* | N210: Bootloader includes TXRX. No longer uses safe firmware as backup fw. | Nick Foster | 2011-04-22 | 1 | -368/+368 |
| | |||||
* | N210: Make new bootloader ignore safe firmware when safe mode button is pushed. | Nick Foster | 2011-04-21 | 1 | -331/+331 |
| | |||||
* | N210: bootram expanded to 16KB (8 BRAMs) and UDP bootloader added | Nick Foster | 2011-04-21 | 1 | -398/+398 |
| | |||||
* | N210: UDP bootloader first stab (16K boot RAM) | Nick Foster | 2011-04-21 | 2 | -172/+428 |
| | |||||
* | Merge branch 'master' into next | Matt Ettus | 2011-03-27 | 3 | -5/+106 |
|\ | | | | | | | | | | | | | * master: u2p: N200 Makefile u1e: use icarus verilog for lint clean up a bunch of warnings and incorrect bus widths | ||||
| * | u2p: N200 Makefile | Matt Ettus | 2011-03-23 | 1 | -0/+98 |
| | | |||||
| * | u1e: use icarus verilog for lint | Matt Ettus | 2011-03-16 | 1 | -0/+2 |
| | | |||||
| * | clean up a bunch of warnings and incorrect bus widths | Matt Ettus | 2011-03-16 | 1 | -5/+6 |
| | | |||||
* | | reverted zpu stack pointer change, incremented fpga compat number | Josh Blum | 2011-03-17 | 2 | -4/+4 |
| | | |||||
* | | memory_reorg: new bootloader.rmi for n210 | Josh Blum | 2011-03-16 | 1 | -154/+154 |
| | | |||||
* | | u2p: fixed bootloader remapping | Matt Ettus | 2011-03-16 | 1 | -35/+32 |
| | | |||||
* | | u2/u2p: reorganized memory map | Matt Ettus | 2011-03-16 | 2 | -51/+45 |
| | | |||||
* | | u2/u2p: fixed instance name | Matt Ettus | 2011-03-16 | 2 | -2/+2 |
| | | |||||
* | | u2/u2p: reworked settings bus addresses | Matt Ettus | 2011-03-16 | 2 | -33/+36 |
|/ | |||||
* | u1e: removed old directory from make | Matt Ettus | 2011-03-15 | 1 | -1/+0 |
| | |||||
* | u1e: keep up with fixes made for u2/u2p, make it compile again | Matt Ettus | 2011-03-15 | 1 | -1/+0 |
| | |||||
* | fix: vita_rx_chain1 should use unit2 (since err0 uses unit1) | Josh Blum | 2011-03-08 | 2 | -2/+2 |
| | |||||
* | u2/u2p: enlarge dsp rx fifos to handle jumbo frames, enable in u2plus as well | Matt Ettus | 2011-03-05 | 2 | -20/+8 |
| | |||||
* | u2/u2p: moved dsp framer into vita_rx_chain | Matt Ettus | 2011-03-05 | 1 | -18/+6 |
| | |||||
* | Merge branch 'gpmc_testing' into ethfifo_reorg | Matt Ettus | 2011-03-03 | 1 | -81/+18 |
|\ | | | | | | | | | | | | | | | | | | | | | | | | | | | * gpmc_testing: timed packet generator : Temporarily use a checksum rather than a crc to validate packet integrity. correct port names fifo36_mux now has shortfifos on the input ports as well as output timed tester : Bring out src/dst flags for rx chain for testing. u1e: hook up tester controls move declarations to before use hook up under/overruns for debug purposes e100: integrate loopback and timed testing into main image Fix endianess for packet length and sequence number for e100 timed image. put these files in the right place. newfifo is long gone. | ||||
| * | timed tester : Bring out src/dst flags for rx chain for testing. | Philip Balister | 2011-02-25 | 1 | -0/+4 |
| | | |||||
| * | u1e: hook up tester controls | Matt Ettus | 2011-02-17 | 1 | -4/+6 |
| | | |||||
| * | hook up under/overruns for debug purposes | Matt Ettus | 2011-02-16 | 1 | -3/+7 |
| | | |||||
| * | e100: integrate loopback and timed testing into main image | Matt Ettus | 2011-02-16 | 1 | -74/+1 |
| | | |||||
* | | remove references to old directory | Matt Ettus | 2011-03-03 | 6 | -7/+1 |
| | | |||||
* | | u2plus: catch up with ethfifo changes which were on u2 | Matt Ettus | 2011-03-03 | 1 | -39/+4 |
| | | |||||
* | | make big tx fifo the one doing the clock crossing | Matt Ettus | 2011-03-03 | 1 | -11/+3 |
| | |