aboutsummaryrefslogtreecommitdiffstats
path: root/host/lib
Commit message (Collapse)AuthorAgeFilesLines
...
| * | | | | e100: ctrl impl changes for header offsetJosh Blum2012-07-161-2/+2
| | | | | |
| * | | | | e100: cleanup and make better use of IRQ gpio for control responseJosh Blum2012-07-161-50/+45
| | | | | |
| * | | | | e100: squashed host code for fifo control/timed commandsJosh Blum2012-07-168-364/+272
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This uses the new b100/e100 common core and FIFO control modules. Subsequent commit will be the compatible FPGA merge. Conflicts: host/lib/usrp/e100/io_impl.cpp
| * | | | | Merge branch 'master' into nextJosh Blum2012-07-163-4/+13
| |\ \ \ \ \
| * | | | | | uhd: make range_t a lightweight objectJosh Blum2012-07-041-15/+6
| | | | | | |
| * | | | | | b100: squashed host code for fifo control/timed commandsJosh Blum2012-07-026-215/+99
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This uses the new b100/e100 common core and FIFO control modules. Subsequent commit will be the compatible FPGA merge.
| * | | | | | usrp: added fifo_ctrl_excelsior for FIFO control + async msgsJosh Blum2012-07-023-1/+358
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | The fifo_ctrl_excelsior is the host code for dealing with E100/B100 control messages and async messages. It also has the SPI implementation. Timed commands are implemented on top of this code.
| * | | | | | transport: multi-threaded send_packet_handlerJosh Blum2012-07-021-25/+77
| | | | | | |
| * | | | | | transport: multi-threaded recv_packet_handlerJosh Blum2012-07-021-22/+71
| | | | | | |
| * | | | | | transport: switch to the atomic claimerJosh Blum2012-07-023-66/+3
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This wont have much effect because the buffers are not currently used in any queue by the caller
* | | | | | | cal: dont interpolate if freq is the same +/- epsilonJosh Blum2012-08-291-0/+12
| |_|_|_|/ / |/| | | | |
* | | | | | usrp2: fix program_stream_dest (arp for dest)Josh Blum2012-08-141-0/+1
| |_|_|/ / |/| | | | | | | | | | | | | | The send buffer should be reset ASAP so it gets flushed out.
* | | | | sbx/wbx: clear R/N counters before tuning the LOJosh Blum2012-08-087-3/+26
| |_|/ / |/| | | | | | | | | | | This helps consistent phase offset between mixers when a timed tune is performed.
* | | | usb: added recv buffer flushing to libusb zero copyJosh Blum2012-08-041-1/+18
| | | |
* | | | Merge branch 'maint'Josh Blum2012-08-011-1/+1
|\ \ \ \ | |_|/ / |/| | / | | |/ | |/|
| * | xcvr2450: disable transmit PAs when receivingJosh Blum2012-08-011-2/+2
| | |
* | | Merge branch 'maint'Josh Blum2012-07-161-1/+4
|\| |
| * | e100: set vita header offset for previous FPGA changesetJosh Blum2012-07-161-1/+4
| | |
* | | usrp: cache writes to gpio pins (avoids overhead)Josh Blum2012-07-061-1/+7
| | |
* | | lib: FW/FPGA compatibility error prompts user to use regular card/net burner ↵Nicholas Corgan2012-07-061-2/+2
| |/ |/| | | | | instead of gui
* | usrp1: wrap around for DAC tuning outside 1st nyquistJosh Blum2012-06-281-1/+8
| |
* | Merge branch 'maint'Josh Blum2012-06-281-36/+2
|\|
| * usrp1: revert calculation for DAC freq outside of 1st NyquistJosh Blum2012-06-281-36/+2
| | | | | | | | This patch does not work. A possibile solution will be added to master.
* | usrp2: MAX_SEQS_OUT-1 because ack comes after sendJosh Blum2012-06-191-1/+1
| |
* | Merge branch 'maint'Josh Blum2012-06-181-1/+1
|\|
| * xcvr2450: fix to disable LO offset for TX sideJosh Blum2012-06-181-1/+1
| | | | | | | | | | | | | | | | | | | | XCVR2450 has a common LO for RX and TX. The use LO offset should be the same for both sides. When different, a tune for one side will override the other side, because the DSP will not know the compensation factor after the other side is tuned. Setting both use_lo_offset to false is how this was pre 3.4 release.
* | n2x0: only check for the GPSDO once after power upJosh Blum2012-06-182-9/+39
| | | | | | | | | | | | We used to only check if the EEPROM was setup properly. But now we always check, but check only once after first power up, and disable the check if not found.
* | usrp2: created fw peek/poke functionsJosh Blum2012-06-182-6/+22
| |
* | usb: prefer to stop the task explicitlyJosh Blum2012-06-131-0/+6
| |
* | RFX: added support for calibration utilsJosh Blum2012-06-121-1/+1
| | | | | | | | | | Special CAL RX antenna rule: keep mixer enabled to reduce transients. 0 dB gains settings for RX and TX to deal with RFX sensitivity range.
* | convert: add sc8 host to/from sc8 wire formatJosh Blum2012-06-122-0/+27
| |
* | wbx: dont sync for lower rates so we can lockJosh Blum2012-06-083-21/+36
| |
* | utils: UHD Image Downloader - downloads firmware/FPGA images compatible with ↵Nicholas Corgan2012-06-074-25/+39
| | | | | | | | the current host code and places them in the images directory
* | usrp2: fix fw bug for spi transact (order of operations)Josh Blum2012-06-071-1/+1
| |
* | uhd: added uhd::get_pkg_data_pathJosh Blum2012-06-051-4/+5
| |
* | usrp: clear rx dsp on deconstructionJosh Blum2012-06-051-0/+10
| |
* | usb: created autoflusher task in usb_zero_copy_wrapperJosh Blum2012-06-051-2/+45
| | | | | | | | | | Since we dont commit buffers ASAP until filled, autoflusher will do this if timeout occurs.
* | Merge branch 'maint'Josh Blum2012-05-301-1/+6
|\|
| * usrp1: shutoff DAC digital w/ TX state machineJosh Blum2012-05-301-1/+6
| |
* | usrp: added control for sr based i2c coreJosh Blum2012-05-303-0/+194
| |
* | gpsdo: added "gpsdo" clock and time source optionsJosh Blum2012-05-184-10/+22
| | | | | | | | When an on-board GPSDO is detected, "gpsdo" is added to the options.
* | Merge branch 'maint'Josh Blum2012-05-171-2/+36
|\|
| * usrp1: removed print from codec_ctrl last commitJosh Blum2012-05-171-1/+1
| |
| * Fixing USRP1 aliasing logicNicholas Corgan2012-05-171-2/+36
| |
* | uhd: used shared get_tmp_path for logging as wellJosh Blum2012-05-162-46/+31
| | | | | | | | Moved some of the log.cpp tmp paths smarts into paths as well
* | Merge branch 'maint'Josh Blum2012-05-162-6/+2
|\| | | | | | | | | Conflicts: host/docs/gpsdo.rst
| * Removed GPGSA from GPS driver since Firefly doesn't actually support it.Nick Foster2012-05-161-5/+1
| |
| * b100: fix use of boost cstdint hereJosh Blum2012-05-161-1/+1
| |
* | usrp: mboard eeprom map use string as keyJosh Blum2012-05-1410-25/+27
| |
* | Merge branch 'maint'Josh Blum2012-05-142-1/+3
|\|