aboutsummaryrefslogtreecommitdiffstats
Commit message (Collapse)AuthorAgeFilesLines
...
| * 24 bit wide z. Can't do this parameterized, unfortunately.matt2009-01-193-5/+132
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@10256 221aa14e-8319-0410-a670-987f0aec2ac5
| * pps sync works, meets timingmatt2008-12-152-13/+26
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@10120 221aa14e-8319-0410-a670-987f0aec2ac5
| * synchronized pps, lots of debug pins changed, works, meets timingmatt2008-12-141-49/+71
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@10118 221aa14e-8319-0410-a670-987f0aec2ac5
| * reset the phase when we shut down. Aids in syncmatt2008-12-132-3/+7
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@10115 221aa14e-8319-0410-a670-987f0aec2ac5
| * implemented "reset master clock on next PPS" so we can easily sync multiple ↵matt2008-12-051-12/+31
| | | | | | | | | | | | units without MIMO connections git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@10103 221aa14e-8319-0410-a670-987f0aec2ac5
| * speed up the diagnostic signals, they were causing timing problemsmatt2008-12-042-13/+65
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@10101 221aa14e-8319-0410-a670-987f0aec2ac5
| * hardware control of ledsmatt2008-11-091-2/+16
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9961 221aa14e-8319-0410-a670-987f0aec2ac5
| * u2_rev2 now works againmatt2008-10-231-1/+3
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9831 221aa14e-8319-0410-a670-987f0aec2ac5
| * make rev2 compile againmatt2008-10-221-1/+2
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9815 221aa14e-8319-0410-a670-987f0aec2ac5
| * added in mux for DACsmatt2008-10-181-4/+16
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9807 221aa14e-8319-0410-a670-987f0aec2ac5
| * Added firmware support for adc_mux to handle swapping I/Q, etc. Modified ↵eb2008-10-151-5/+14
| | | | | | | | | | | | | | | | | | | | | | | | dsp_core_rx.v to swap A and B mapping so that the software thinks that the TVRX is connected to A/D A. ISE 10.1 SP3 is required to compile the FPGA successfully. SP2 is insufficient. It compiles with SP2, but the firmware doesn't load. Only the F led is one in that case. git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9795 221aa14e-8319-0410-a670-987f0aec2ac5
| * New serdes status interrupt, clk_status interrupt. New capability to flush ↵matt2008-10-114-8/+16
| | | | | | | | | | | | the ICache. git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9779 221aa14e-8319-0410-a670-987f0aec2ac5
| * moved to appropriate placesmatt2008-10-081-0/+0
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9747 221aa14e-8319-0410-a670-987f0aec2ac5
| * added the basic wb<-->extram interface and a serdes interrupt to tell link ↵matt2008-10-084-40/+66
| | | | | | | | | | | | status git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9746 221aa14e-8319-0410-a670-987f0aec2ac5
| * catch up with latest pin defs of u2_corematt2008-09-211-1/+3
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9636 221aa14e-8319-0410-a670-987f0aec2ac5
| * attach a 16 bit device to the bus and make it look like a 32 bit devicematt2008-09-211-0/+36
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9635 221aa14e-8319-0410-a670-987f0aec2ac5
| * wb_zbt16_b is a quick hack just to be able to safely check the sram. it is ↵matt2008-09-212-5/+68
| | | | | | | | | | | | not speed-optimized git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9633 221aa14e-8319-0410-a670-987f0aec2ac5
| * new directory for filesmatt2008-09-211-0/+1
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9632 221aa14e-8319-0410-a670-987f0aec2ac5
| * zbt ram controllermatt2008-09-215-0/+153
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9631 221aa14e-8319-0410-a670-987f0aec2ac5
| * first cutmatt2008-09-191-0/+146
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9609 221aa14e-8319-0410-a670-987f0aec2ac5
| * better debug pinsmatt2008-09-171-2/+3
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9592 221aa14e-8319-0410-a670-987f0aec2ac5
| * allow fpga to take over sd card interface from cpldmatt2008-09-172-9/+29
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9591 221aa14e-8319-0410-a670-987f0aec2ac5
| * allow fpga to take over SD card interfacematt2008-09-171-4/+13
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9590 221aa14e-8319-0410-a670-987f0aec2ac5
| * control CS line on SD cardmatt2008-09-171-1/+11
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9589 221aa14e-8319-0410-a670-987f0aec2ac5
| * Merged r9505:9553 from old usrp2/trunk into trunk/usrp2jcorgan2008-09-115-37/+64
| | | | | | | | git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9555 221aa14e-8319-0410-a670-987f0aec2ac5
| * Merged r9433:9527 from features/gr-usrp2 into trunk. Adds usrp2 and ↵jcorgan2008-09-081060-0/+1630060
| | | | | | gr-usrp2 top-level components. Trunk passes distcheck with mb-gcc installed, but currently not without them. The key issue is that when mb-gcc is not installed, the build system skips over the usrp2/firmware directory, and the firmware include files don't get put into the dist tarball. But we can't do the usual DIST_SUBDIRS method as the firmware is a subpackage. git-svn-id: http://gnuradio.org/svn/gnuradio/trunk@9528 221aa14e-8319-0410-a670-987f0aec2ac5
* work on tuning rfx tx and rx LOsJosh Blum2010-04-141-27/+75
|
* removed some windows warningsJosh Blum2010-04-143-7/+7
|
* Added gain control to rfx. Switched string constants to caps (gains, ↵Josh Blum2010-04-145-25/+55
| | | | | | antennas, subdevs). Made dboard interface for aux dac and adc use volts.
* work on atr bits in rfx boardJosh Blum2010-04-141-11/+21
|
* removed clock rate prop, we dont need to expose that since ticks are in nsecsJosh Blum2010-04-144-10/+0
|
* renamed dxc to dsp for tune resultJosh Blum2010-04-144-8/+8
|
* renamed dboard interface to dboard iface, the lengthy name was getting to be ↵Josh Blum2010-04-1410-68/+68
| | | | a burden
* work on rfx atr regsJosh Blum2010-04-131-1/+30
|
* Created a usrp2 interface class with the control, spi, peek/poke functionality.Josh Blum2010-04-1312-222/+378
| | | | Its used in all the implementation level code
* added adc and dac clock enablesJosh Blum2010-04-131-2/+34
|
* removed unused firmware codeJosh Blum2010-04-133-370/+0
|
* Moved ad9777 control 100% on to the hostJosh Blum2010-04-137-172/+29
|
* added ad9777 register mapJosh Blum2010-04-132-0/+208
|
* added more clock config, takes care of external referenceJosh Blum2010-04-134-1/+61
|
* Moved clock control into abstraction clock control class.Josh Blum2010-04-137-37/+167
|
* Merge branch 'master' of git@ettus.sourcerepo.com:ettus/uhd into usrp2Josh Blum2010-04-133-51/+72
|\
| * Merge branch 'master' of git@ettus.sourcerepo.com:ettus/uhdJosh Blum2010-04-132-49/+0
| |\
| | * forgot dangling fileJosh Blum2010-04-132-49/+0
| | |
| * | added reqs and build instructions to readmeJosh Blum2010-04-131-2/+72
| |/
* | controlling dboard clock enables from hostJosh Blum2010-04-123-20/+57
| |
* | reg map for ad9510Josh Blum2010-04-122-0/+220
| |
* | merged unit type and gpio bank for dboard interface into one type, expanded ↵Josh Blum2010-04-125-85/+98
| | | | | | | | dboard clock config api
* | Merge branch 'master' of git@ettus.sourcerepo.com:ettus/uhd into usrp2Josh Blum2010-04-122-41/+0
|\|
| * removed dummy placeholderJosh Blum2010-04-122-41/+0
| |
generated by cgit v1.2.3 (git 2.39.1) at 2025-03-15 12:20:39 +0000