aboutsummaryrefslogtreecommitdiffstats
Commit message (Collapse)AuthorAgeFilesLines
* modernize the make files, it now compiles. not tested.Matt Ettus2011-05-262-56/+10
|
* select bus is 2 bits wideNick Foster2011-05-261-1/+1
|
* I2C slave address decoding for 16-bit dw instead of 32-bitNick Foster2011-05-261-1/+1
|
* Fixed I2C pin names.Nick Foster2011-05-261-1/+1
|
* add padding into gpif response pathMatt Ettus2011-05-263-4/+16
|
* pad out packets to a minimum lengthMatt Ettus2011-05-262-1/+76
|
* fixed length command packetsMatt Ettus2011-05-261-1/+1
|
* give response packets the same format as tx packetsMatt Ettus2011-05-261-1/+13
|
* successful testMatt Ettus2011-05-261-0/+104
|
* old and unusedMatt Ettus2011-05-261-151/+0
|
* put gpio back inMatt Ettus2011-05-261-4/+3
|
* fifo to wb should be functionally complete, needs testingMatt Ettus2011-05-263-34/+150
|
* not usedMatt Ettus2011-05-261-16/+0
|
* fix ctrl/resp path to pass all 16 bits of data instead of the bottom bitMatt Ettus2011-05-263-38/+47
| | | | | typos fixed, everything is connected now, should just have off-by-1 error lots of debug pins added
* send reset to the gpifMatt Ettus2011-05-261-2/+3
|
* constrain the gpif clockMatt Ettus2011-05-261-0/+3
|
* first steps to a command packet handler for u1+Matt Ettus2011-05-262-0/+17
|
* redone gpif interface to match nick's new specMatt Ettus2011-05-264-62/+125
|
* use vita_tx_chain top level blockMatt Ettus2011-05-261-22/+14
|
* hook up flow control pinsMatt Ettus2011-05-261-2/+10
|
* added a loopback control port, will do full wishbone interface laterMatt Ettus2011-05-263-7/+50
|
* progress on gpif interfaceMatt Ettus2011-05-264-110/+119
|
* gpif skeletonsMatt Ettus2011-05-267-134/+111
|
* skeletonMatt Ettus2011-05-261-0/+122
|
* copied over from u1e, most pins hooked up.Matt Ettus2011-05-266-637/+588
|
* Use the 4th LED which is shared on the cfg_init_b pinMatt Ettus2011-05-262-6/+10
|
* compiles nowMatt Ettus2011-05-264-643/+185
|
* copied over from other repo. Beginnings of a skeleton fpga image for USRP1-PlusMatt Ettus2011-05-2611-0/+1854
|
* u1e: incremented compat # to 4 for vita length changeJosh Blum2011-05-201-1/+1
|
* N210: how the heck did the PPS fix get dropped againNick Foster2011-05-201-1/+4
|
* u1e: get dsp_framer36 from u1p so it can skip the protocol headerMatt Ettus2011-05-094-10/+100
|
* u1e: switch to vita_rx_chain module just like other toplevelsMatt Ettus2011-05-092-20/+11
|
* N210: Bootloader includes TXRX. No longer uses safe firmware as backup fw.Nick Foster2011-04-221-368/+368
|
* N210: Make new bootloader ignore safe firmware when safe mode button is pushed.Nick Foster2011-04-211-331/+331
|
* N210: bootram expanded to 16KB (8 BRAMs) and UDP bootloader addedNick Foster2011-04-212-496/+541
|
* N210: UDP bootloader first stab (16K boot RAM)Nick Foster2011-04-212-172/+428
|
* Merge branch 'master' into nextMatt Ettus2011-03-2710-34/+120
|\ | | | | | | | | | | | | * master: u2p: N200 Makefile u1e: use icarus verilog for lint clean up a bunch of warnings and incorrect bus widths
| * u2p: N200 MakefileMatt Ettus2011-03-231-0/+98
| |
| * u1e: use icarus verilog for lintMatt Ettus2011-03-161-0/+2
| |
| * clean up a bunch of warnings and incorrect bus widthsMatt Ettus2011-03-168-34/+20
| |
* | reverted zpu stack pointer change, incremented fpga compat numberJosh Blum2011-03-178-12/+12
| |
* | memory_reorg: new bootloader.rmi for n210Josh Blum2011-03-161-154/+154
| |
* | u2p: fixed bootloader remappingMatt Ettus2011-03-161-35/+32
| |
* | u2/u2p: reorganized memory mapMatt Ettus2011-03-162-51/+45
| |
* | u2/u2p: fixed instance nameMatt Ettus2011-03-162-2/+2
| |
* | udp: alternate udp portsMatt Ettus2011-03-161-1/+1
| |
* | udp: look for checksum in the right placeMatt Ettus2011-03-161-2/+2
| |
* | udp: fix precomputation of ip header checksumMatt Ettus2011-03-161-3/+9
| |
* | simple_gemac: fixed typo for tx_clk and tweaked ethtx_realign.vJosh Blum2011-03-162-26/+28
| |
* | eth: the danger of cut and pasteMatt Ettus2011-03-161-2/+2
| |