| Commit message (Expand) | Author | Age | Files | Lines |
... | |
* | new fifos copied over from other project | matt | 2009-03-30 | 17 | -0/+6741 |
* | optional (but not used) additional buffering in eth rx path. | matt | 2009-03-30 | 1 | -0/+11 |
* | comment out the RMON, which we don't use | matt | 2009-03-30 | 1 | -2/+2 |
* | copied over old one which works with icarus | matt | 2009-03-09 | 1 | -1689/+1090 |
* | timing fix. The line address in the buffers still updates now even if there ... | matt | 2009-02-26 | 1 | -1/+61 |
* | timing fix, delays the ethernet flow control by a cycle to get it across the ... | matt | 2009-02-26 | 2 | -3/+16 |
* | remove support for unmodified dbsrx because there is way too much phase noise... | matt | 2009-02-26 | 1 | -9/+1 |
* | set all debug stuff to zero | matt | 2009-02-24 | 1 | -13/+10 |
* | support for unmodified dbsrx boards | matt | 2009-02-23 | 1 | -1/+9 |
* | Merged r10418:10423 from jcorgan/pps into trunk. Adds usrp2::sync_every_pps | jcorgan | 2009-02-10 | 1 | -1/+4 |
* | work in progress | matt | 2009-01-31 | 1 | -0/+2 |
* | work in progress | matt | 2009-01-31 | 2 | -0/+382 |
* | work in progress | matt | 2009-01-31 | 1 | -0/+95 |
* | first cut at 64 bit time | matt | 2009-01-31 | 1 | -0/+63 |
* | trial fix for problem when 3 loads with 1 wait state are followed by a barrel... | matt | 2009-01-22 | 1 | -2/+2 |
* | catching up with shawn. these aren't used here anyway. | matt | 2009-01-22 | 2 | -10/+16 |
* | detect loss of signal | matt | 2009-01-22 | 1 | -1/+2 |
* | corrected link up detector | matt | 2009-01-19 | 1 | -1/+1 |
* | new cordic | matt | 2009-01-19 | 2 | -0/+2 |
* | widen cordic on tx side | matt | 2009-01-19 | 1 | -6/+12 |
* | clarify comment | matt | 2009-01-19 | 1 | -1/+1 |
* | 24 bit wide z. Can't do this parameterized, unfortunately. | matt | 2009-01-19 | 3 | -5/+132 |
* | pps sync works, meets timing | matt | 2008-12-15 | 2 | -13/+26 |
* | synchronized pps, lots of debug pins changed, works, meets timing | matt | 2008-12-14 | 1 | -49/+71 |
* | reset the phase when we shut down. Aids in sync | matt | 2008-12-13 | 2 | -3/+7 |
* | implemented "reset master clock on next PPS" so we can easily sync multiple u... | matt | 2008-12-05 | 1 | -12/+31 |
* | speed up the diagnostic signals, they were causing timing problems | matt | 2008-12-04 | 2 | -13/+65 |
* | hardware control of leds | matt | 2008-11-09 | 1 | -2/+16 |
* | u2_rev2 now works again | matt | 2008-10-23 | 1 | -1/+3 |
* | make rev2 compile again | matt | 2008-10-22 | 1 | -1/+2 |
* | added in mux for DACs | matt | 2008-10-18 | 1 | -4/+16 |
* | Added firmware support for adc_mux to handle swapping I/Q, etc. Modified dsp_... | eb | 2008-10-15 | 1 | -5/+14 |
* | New serdes status interrupt, clk_status interrupt. New capability to flush t... | matt | 2008-10-11 | 4 | -8/+16 |
* | moved to appropriate places | matt | 2008-10-08 | 1 | -0/+0 |
* | added the basic wb<-->extram interface and a serdes interrupt to tell link st... | matt | 2008-10-08 | 4 | -40/+66 |
* | catch up with latest pin defs of u2_core | matt | 2008-09-21 | 1 | -1/+3 |
* | attach a 16 bit device to the bus and make it look like a 32 bit device | matt | 2008-09-21 | 1 | -0/+36 |
* | wb_zbt16_b is a quick hack just to be able to safely check the sram. it is n... | matt | 2008-09-21 | 2 | -5/+68 |
* | new directory for files | matt | 2008-09-21 | 1 | -0/+1 |
* | zbt ram controller | matt | 2008-09-21 | 5 | -0/+153 |
* | first cut | matt | 2008-09-19 | 1 | -0/+146 |
* | better debug pins | matt | 2008-09-17 | 1 | -2/+3 |
* | allow fpga to take over sd card interface from cpld | matt | 2008-09-17 | 2 | -9/+29 |
* | allow fpga to take over SD card interface | matt | 2008-09-17 | 1 | -4/+13 |
* | control CS line on SD card | matt | 2008-09-17 | 1 | -1/+11 |
* | Merged r9505:9553 from old usrp2/trunk into trunk/usrp2 | jcorgan | 2008-09-11 | 5 | -37/+64 |
* | Merged r9433:9527 from features/gr-usrp2 into trunk. Adds usrp2 and gr-usrp2... | jcorgan | 2008-09-08 | 1060 | -0/+1630060 |