diff options
Diffstat (limited to 'usrp2/top')
| -rw-r--r-- | usrp2/top/u2_rev3/u2_core_udp.v | 17 |
1 files changed, 9 insertions, 8 deletions
diff --git a/usrp2/top/u2_rev3/u2_core_udp.v b/usrp2/top/u2_rev3/u2_core_udp.v index 798022adc..b034791a7 100644 --- a/usrp2/top/u2_rev3/u2_core_udp.v +++ b/usrp2/top/u2_rev3/u2_core_udp.v @@ -180,6 +180,11 @@ module u2_core wire [31:0] irq; wire [63:0] vita_time; + wire run_rx, run_tx; + reg run_rx_d1; + always @(posedge dsp_clk) + run_rx_d1 <= run_rx; + // /////////////////////////////////////////////////////////////////////////////////////////////// // Wishbone Single Master INTERCON localparam dw = 32; // Data bus width @@ -509,12 +514,13 @@ module u2_core // In Rev3 there are only 6 leds, and the highest one is on the ETH connector wire [7:0] led_src, led_sw; - wire [7:0] led_hw = {clk_status,serdes_link_up}; + wire [7:0] led_hw = {run_tx, run_rx, clk_status, serdes_link_up, 1'b0}; setting_reg #(.my_addr(3),.width(8)) sr_led (.clk(wb_clk),.rst(wb_rst),.strobe(set_stb),.addr(set_addr), .in(set_data),.out(led_sw),.changed()); - setting_reg #(.my_addr(8),.width(8)) sr_led_src (.clk(wb_clk),.rst(wb_rst),.strobe(set_stb),.addr(set_addr), - .in(set_data),.out(led_src),.changed()); + + setting_reg #(.my_addr(8),.width(8), .at_reset(8'b0001_1110)) + sr_led_src (.clk(wb_clk),.rst(wb_rst), .strobe(set_stb),.addr(set_addr), .in(set_data),.out(led_src),.changed()); assign leds = (led_src & led_hw) | (~led_src & led_sw); @@ -565,11 +571,6 @@ module u2_core // ///////////////////////////////////////////////////////////////////////// // ATR Controller, Slave #11 - wire run_rx, run_tx; - reg run_rx_d1; - always @(posedge dsp_clk) - run_rx_d1 <= run_rx; - atr_controller atr_controller (.clk_i(wb_clk),.rst_i(wb_rst), .adr_i(sb_adr[5:0]),.sel_i(sb_sel),.dat_i(sb_dat_o),.dat_o(sb_dat_i), |