diff options
Diffstat (limited to 'usrp2/top/E1x0/u1e.v')
| -rw-r--r-- | usrp2/top/E1x0/u1e.v | 141 |
1 files changed, 141 insertions, 0 deletions
diff --git a/usrp2/top/E1x0/u1e.v b/usrp2/top/E1x0/u1e.v new file mode 100644 index 000000000..445b14a03 --- /dev/null +++ b/usrp2/top/E1x0/u1e.v @@ -0,0 +1,141 @@ +`timescale 1ns / 1ps +////////////////////////////////////////////////////////////////////////////////// + +module u1e + (input CLK_FPGA_P, input CLK_FPGA_N, // Diff + output [3:0] debug_led, output [31:0] debug, output [1:0] debug_clk, + input debug_pb, output FPGA_TXD, input FPGA_RXD, + + // GPMC + input EM_CLK, inout [15:0] EM_D, input [10:1] EM_A, input [1:0] EM_NBE, + input EM_WAIT0, input EM_NCS4, input EM_NCS5, input EM_NCS6, + input EM_NWE, input EM_NOE, + + inout db_sda, inout db_scl, // I2C + + output db_sclk_tx, output db_sen_tx, output db_mosi_tx, input db_miso_tx, // DB TX SPI + output db_sclk_rx, output db_sen_rx, output db_mosi_rx, input db_miso_rx, // DB TX SPI + output sclk_codec, output sen_codec, output mosi_codec, input miso_codec, // AD9862 main SPI + output cgen_sclk, output cgen_sen_b, output cgen_mosi, input cgen_miso, // Clock gen SPI + + input cgen_st_status, input cgen_st_ld, input cgen_st_refmon, output cgen_sync_b, output cgen_ref_sel, + + output overo_gpio144, output overo_gpio145, output overo_gpio146, output overo_gpio147, // Fifo controls + input overo_gpio0, input overo_gpio14, input overo_gpio21, input overo_gpio22, // Misc GPIO + input overo_gpio23, input overo_gpio64, input overo_gpio65, input overo_gpio127, // Misc GPIO + input overo_gpio128, input overo_gpio163, input overo_gpio170, input overo_gpio176, // Misc GPIO + + inout [15:0] io_tx, inout [15:0] io_rx, + + output [13:0] TX, output TXSYNC, output TXBLANK, + input [11:0] DA, input [11:0] DB, input RXSYNC, + + input PPS_IN + ); + + // ///////////////////////////////////////////////////////////////////////// + // Clocking + wire clk_fpga, clk_fpga_in; + + IBUFGDS #(.IOSTANDARD("LVDS_33"), .DIFF_TERM("TRUE")) + clk_fpga_pin (.O(clk_fpga_in),.I(CLK_FPGA_P),.IB(CLK_FPGA_N)); + + wire clk_2x, dcm_rst, dcm_locked, clk_fb; + DCM #(.CLK_FEEDBACK ( "1X" ), + .CLKDV_DIVIDE ( 2 ), + .CLKFX_DIVIDE ( 2 ), + .CLKFX_MULTIPLY ( 2 ), + .CLKIN_DIVIDE_BY_2 ( "FALSE" ), + .CLKIN_PERIOD ( 15.625 ), + .CLKOUT_PHASE_SHIFT ( "NONE" ), + .DESKEW_ADJUST ( "SYSTEM_SYNCHRONOUS" ), + .DFS_FREQUENCY_MODE ( "LOW" ), + .DLL_FREQUENCY_MODE ( "LOW" ), + .DUTY_CYCLE_CORRECTION ( "TRUE" ), + .FACTORY_JF ( 16'h8080 ), + .PHASE_SHIFT ( 0 ), + .STARTUP_WAIT ( "FALSE" )) + clk_doubler (.CLKFB(clk_fb), .CLKIN(clk_fpga_in), .RST(dcm_rst), + .DSSEN(0), .PSCLK(0), .PSEN(0), .PSINCDEC(0), .PSDONE(), + .CLKDV(), .CLKFX(), .CLKFX180(), + .CLK2X(), .CLK2X180(), + .CLK0(clk_fb), .CLK90(clk_fpga), .CLK180(), .CLK270(), + .LOCKED(dcm_locked), .STATUS()); + + // ///////////////////////////////////////////////////////////////////////// + // SPI + wire mosi, sclk, miso; + assign { db_sclk_tx, db_mosi_tx } = ~db_sen_tx ? {sclk,mosi} : 2'b0; + assign { db_sclk_rx, db_mosi_rx } = ~db_sen_rx ? {sclk,mosi} : 2'b0; + assign { sclk_codec, mosi_codec } = ~sen_codec ? {sclk,mosi} : 2'b0; + assign { cgen_sclk, cgen_mosi } = ~cgen_sen_b ? {sclk,mosi} : 2'b0; + assign miso = (~db_sen_tx & db_miso_tx) | (~db_sen_rx & db_miso_rx) | + (~sen_codec & miso_codec) | (~cgen_sen_b & cgen_miso); + + // ///////////////////////////////////////////////////////////////////////// + // TX DAC -- handle the interleaved data bus to DAC, with clock doubling DLL + + assign TXBLANK = 0; + wire [13:0] tx_i, tx_q; + + reg[13:0] delay_q; + always @(posedge clk_fpga) + delay_q <= tx_q; + + genvar i; + generate + for(i=0;i<14;i=i+1) + begin : gen_dacout + ODDR2 #(.DDR_ALIGNMENT("NONE"), // Sets output alignment to "NONE", "C0" or "C1" + .INIT(1'b0), // Sets initial state of the Q output to 1'b0 or 1'b1 + .SRTYPE("SYNC")) // Specifies "SYNC" or "ASYNC" set/reset + ODDR2_inst (.Q(TX[i]), // 1-bit DDR output data + .C0(clk_fpga), // 1-bit clock input + .C1(~clk_fpga), // 1-bit clock input + .CE(1'b1), // 1-bit clock enable input + .D0(tx_i[i]), // 1-bit data input (associated with C0) + .D1(delay_q[i]), // 1-bit data input (associated with C1) + .R(1'b0), // 1-bit reset input + .S(1'b0)); // 1-bit set input + end // block: gen_dacout + endgenerate + ODDR2 #(.DDR_ALIGNMENT("NONE"), // Sets output alignment to "NONE", "C0" or "C1" + .INIT(1'b0), // Sets initial state of the Q output to 1'b0 or 1'b1 + .SRTYPE("SYNC")) // Specifies "SYNC" or "ASYNC" set/reset + ODDR2_txsnc (.Q(TXSYNC), // 1-bit DDR output data + .C0(clk_fpga), // 1-bit clock input + .C1(~clk_fpga), // 1-bit clock input + .CE(1'b1), // 1-bit clock enable input + .D0(1'b0), // 1-bit data input (associated with C0) + .D1(1'b1), // 1-bit data input (associated with C1) + .R(1'b0), // 1-bit reset input + .S(1'b0)); // 1-bit set input + + // ///////////////////////////////////////////////////////////////////////// + // Main U1E Core + u1e_core u1e_core(.clk_fpga(clk_fpga), .rst_fpga(~debug_pb), + .debug_led(debug_led), .debug(debug), .debug_clk(debug_clk), + .debug_txd(FPGA_TXD), .debug_rxd(FPGA_RXD), + .EM_CLK(EM_CLK), .EM_D(EM_D), .EM_A(EM_A), .EM_NBE(EM_NBE), + .EM_WAIT0(EM_WAIT0), .EM_NCS4(EM_NCS4), .EM_NCS5(EM_NCS5), + .EM_NCS6(EM_NCS6), .EM_NWE(EM_NWE), .EM_NOE(EM_NOE), + .db_sda(db_sda), .db_scl(db_scl), + .sclk(sclk), .sen({cgen_sen_b,sen_codec,db_sen_tx,db_sen_rx}), .mosi(mosi), .miso(miso), + .cgen_st_status(cgen_st_status), .cgen_st_ld(cgen_st_ld),.cgen_st_refmon(cgen_st_refmon), + .cgen_sync_b(cgen_sync_b), .cgen_ref_sel(cgen_ref_sel), + .tx_have_space(overo_gpio144), .tx_underrun(overo_gpio145), + .rx_have_data(overo_gpio146), .rx_overrun(overo_gpio147), + .io_tx(io_tx), .io_rx(io_rx), + .tx_i(tx_i), .tx_q(tx_q), + .rx_i(DA), .rx_q(DB), + .misc_gpio( {{overo_gpio128,overo_gpio163,overo_gpio170,overo_gpio176}, + {overo_gpio0,overo_gpio14,overo_gpio21,overo_gpio22}, + {overo_gpio23,overo_gpio64,overo_gpio65,overo_gpio127}}), + .pps_in(PPS_IN) ); + + // ///////////////////////////////////////////////////////////////////////// + // Local Debug + // assign debug_clk = {clk_fpga, clk_2x }; + // assign debug = { TXSYNC, TXBLANK, TX }; + +endmodule // u1e |