diff options
Diffstat (limited to 'usrp2/serdes/serdes_tx.v')
| -rw-r--r-- | usrp2/serdes/serdes_tx.v | 186 |
1 files changed, 186 insertions, 0 deletions
diff --git a/usrp2/serdes/serdes_tx.v b/usrp2/serdes/serdes_tx.v new file mode 100644 index 000000000..2e5e3bd80 --- /dev/null +++ b/usrp2/serdes/serdes_tx.v @@ -0,0 +1,186 @@ + +// SERDES Interface + +// LS-Byte is sent first, MS-Byte is second +// Invalid K Codes +// K0.0 000-00000 Error detected +// K31.7 111-11111 Loss of input signal + +// Valid K Codes +// K28.0 000-11100 +// K28.1 001-11100 Alternate COMMA? +// K28.2 010-11100 +// K28.3 011-11100 +// K28.4 100-11100 +// K28.5 101-11100 Standard COMMA? +// K28.6 110-11100 +// K28.7 111-11100 Bad COMMA? +// K23.7 111-10111 +// K27.7 111-11011 +// K29.7 111-11101 +// K30.7 111-11110 + +module serdes_tx + #(parameter FIFOSIZE = 9) + (input clk, + input rst, + + // TX HW Interface + output ser_tx_clk, + output reg [15:0] ser_t, + output reg ser_tklsb, + output reg ser_tkmsb, + + // TX Stream Interface + input [31:0] rd_dat_i, + input [3:0] rd_flags_i, + output rd_ready_o, + input rd_ready_i, + + // Flow control interface + input inhibit_tx, + input send_xon, + input send_xoff, + output sent, + + // FIFO Levels + output [15:0] fifo_occupied, + output fifo_full, + output fifo_empty, + + // DEBUG + output [31:0] debug + ); + + localparam K_COMMA = 8'b101_11100; // 0xBC K28.5 + localparam K_IDLE = 8'b001_11100; // 0x3C K28.1 + localparam K_PKT_START = 8'b110_11100; // 0xDC K28.6 + localparam K_PKT_END = 8'b100_11100; // 0x9C K28.4 + localparam K_XON = 8'b010_11100; // 0x5C K28.2 + localparam K_XOFF = 8'b011_11100; // 0x7C K28.3 + localparam K_LOS = 8'b111_11111; // 0xFF K31.7 + localparam K_ERROR = 8'b000_00000; // 0x00 K00.0 + localparam D_56 = 8'b110_00101; // 0xC5 D05.6 + assign ser_tx_clk = clk; + + localparam IDLE = 3'd0; + localparam RUN1 = 3'd1; + localparam RUN2 = 3'd2; + localparam DONE = 3'd3; + localparam SENDCRC = 3'd4; + localparam WAIT = 3'd5; + + reg [2:0] state; + + reg [15:0] CRC; + wire [15:0] nextCRC; + reg [3:0] wait_count; + + // Internal FIFO, size 9 is 2K, size 10 is 4K bytes + wire sop_o, eop_o; + wire [31:0] data_o; + + wire rd_sop_i = rd_flags_i[0]; + wire rd_eop_i = rd_flags_i[1]; + wire [1:0] rd_occ_i = rd_flags_i[3:2]; // Unused + + wire have_data, empty, read; + fifo_cascade #(.WIDTH(34),.SIZE(FIFOSIZE)) serdes_tx_fifo + (.clk(clk),.reset(rst),.clear(0), + .datain({rd_sop_i,rd_eop_i,rd_dat_i}), .src_rdy_i(rd_ready_i), .dst_rdy_o(rd_ready_o), + .dataout({sop_o,eop_o,data_o}), .dst_rdy_i(read), .src_rdy_o(have_data), + .space(), .occupied(fifo_occupied) ); + + assign fifo_full = ~rd_ready_o; + assign empty = ~have_data; + assign fifo_empty = empty; + + // FIXME Implement flow control + reg [15:0] second_word; + reg [33:0] pipeline; + + assign read = (~send_xon & ~send_xoff & (state==RUN2)) | ((state==IDLE) & ~empty & ~sop_o); + assign sent = send_xon | send_xoff; + // 2nd half of above probably not necessary. Just in case we get junk between packets + + always @(posedge clk) + if(rst) + begin + state <= IDLE; + wait_count <= 0; + {ser_tkmsb,ser_tklsb,ser_t} <= 18'd0; + //{2'b10,K_COMMA,K_COMMA}; + // make tkmsb and tklsb different so they can go in IOFFs + end + else + if(send_xon) + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b11,K_XON,K_XON}; + else if(send_xoff) + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b11,K_XOFF,K_XOFF}; + else + case(state) + IDLE : + begin + if(sop_o & ~empty & ~inhibit_tx) + begin + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b11,K_PKT_START,K_PKT_START}; + state <= RUN1; + end + else + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b10,K_COMMA,D_56}; + end + RUN1 : + begin + if(empty | inhibit_tx) + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b10,K_COMMA,D_56}; + else + begin + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b00,data_o[15:0]}; + state <= RUN2; + end + end + RUN2 : + begin + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b00,data_o[31:16]}; + if(eop_o) + state <= DONE; + else + state <= RUN1; + end + DONE : + begin + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b11,K_PKT_END,K_PKT_END}; + state <= SENDCRC; + end + SENDCRC : + begin + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b00,CRC}; + state <= WAIT; + wait_count <= 4'd15; + end + WAIT : + begin + {ser_tkmsb,ser_tklsb,ser_t} <= {2'b10,K_COMMA,D_56}; + if(wait_count == 0) + state <= IDLE; + else + wait_count <= wait_count - 1; + end + default + state <= IDLE; + endcase // case(state) + + always @(posedge clk) + if(rst) + CRC <= 16'hFFFF; + else if(state == IDLE) + CRC <= 16'hFFFF; + else if( (~empty & ~inhibit_tx & (state==RUN1)) || (state==RUN2) ) + CRC <= nextCRC; + + CRC16_D16 crc_blk( (state==RUN1) ? data_o[15:0] : data_o[31:16], CRC, nextCRC); + + assign debug = { 28'd0, state[2:0] }; + +endmodule // serdes_tx + |