diff options
Diffstat (limited to 'top')
| -rwxr-xr-x | top/u2_core/u2_core.v | 120 |
1 files changed, 71 insertions, 49 deletions
diff --git a/top/u2_core/u2_core.v b/top/u2_core/u2_core.v index b12a7eaca..0ecb378af 100755 --- a/top/u2_core/u2_core.v +++ b/top/u2_core/u2_core.v @@ -157,6 +157,7 @@ module u2_core wire ser_rx_empty, ser_tx_empty, dsp_rx_empty, dsp_tx_empty, eth_rx_empty, eth_tx_empty, eth_rx_empty2; wire serdes_link_up; + wire epoch; // /////////////////////////////////////////////////////////////////////////////////////////////// // Wishbone Single Master INTERCON @@ -437,7 +438,7 @@ module u2_core // In Rev3 there are only 6 leds, and the highest one is on the ETH connector wire [7:0] led_src, led_sw; - wire [7:0] led_hw = {pps_in,clk_status,serdes_link_up}; + wire [7:0] led_hw = {clk_status,serdes_link_up}; setting_reg #(.my_addr(3)) sr_led (.clk(wb_clk),.rst(wb_rst),.strobe(set_stb),.addr(set_addr), .in(set_data),.out(led_sw),.changed()); @@ -552,13 +553,23 @@ module u2_core // ////////////////////////////////////////////////////////////////////////// // Time Sync, Slave #12 + reg pps_posedge, pps_negedge, pps_pos_d1, pps_neg_d1; + always @(negedge dsp_clk) pps_negedge <= pps_in; + always @(posedge dsp_clk) pps_posedge <= pps_in; + always @(posedge dsp_clk) pps_pos_d1 <= pps_posedge; + always @(posedge dsp_clk) pps_neg_d1 <= pps_negedge; + + wire pps_o; time_sync time_sync (.wb_clk_i(wb_clk),.rst_i(wb_rst), .cyc_i(s12_cyc),.stb_i(s12_stb),.adr_i(s12_adr[4:2]), .we_i(s12_we),.dat_i(s12_dat_o),.dat_o(s12_dat_i),.ack_o(s12_ack), .sys_clk_i(dsp_clk),.master_time_o(master_time), - .pps_in(pps_in),.exp_pps_in(exp_pps_in),.exp_pps_out(exp_pps_out), - .int_o(pps_int) ); + //.pps_posedge(pps_posedge),.pps_negedge(pps_negedge), + .pps_in(pps_negedge), + .exp_pps_in(exp_pps_in),.exp_pps_out(exp_pps_out), + //.int_o(pps_int),.epoch_o(epoch),.pps_o(pps_o) ); + .int_o(pps_int)); assign s12_err = 0; assign s12_rty = 0; @@ -665,47 +676,83 @@ module u2_core // ///////////////////////////////////////////////////////////////////////////////////////// // Debug Pins - + // FIFO Level Debugging - reg [31:0] host_to_dsp_fifo, dsp_to_host_fifo, eth_mac_debug, serdes_to_dsp_fifo, dsp_to_serdes_fifo; - + reg [31:0] host_to_dsp_fifo,dsp_to_host_fifo,eth_mac_debug,serdes_to_dsp_fifo,dsp_to_serdes_fifo; + always @(posedge dsp_clk) serdes_to_dsp_fifo <= { {ser_rx_full,ser_rx_empty,ser_rx_occ[13:0]}, - {dsp_tx_full,dsp_tx_empty,dsp_tx_occ[13:0]} }; + {dsp_tx_full,dsp_tx_empty,dsp_tx_occ[13:0]} }; always @(posedge dsp_clk) dsp_to_serdes_fifo <= { {ser_tx_full,ser_tx_empty,ser_tx_occ[13:0]}, - {dsp_rx_full,dsp_rx_empty,dsp_rx_occ[13:0]} }; - + {dsp_rx_full,dsp_rx_empty,dsp_rx_occ[13:0]} }; + always @(posedge dsp_clk) host_to_dsp_fifo <= { {eth_rx_full,eth_rx_empty,eth_rx_occ[13:0]}, {dsp_tx_full,dsp_tx_empty,dsp_tx_occ[13:0]} }; - + always @(posedge dsp_clk) dsp_to_host_fifo <= { {eth_tx_full,eth_tx_empty,eth_tx_occ[13:0]}, - {dsp_rx_full,dsp_rx_empty,dsp_rx_occ[13:0]} }; - + {dsp_rx_full,dsp_rx_empty,dsp_rx_occ[13:0]} }; + always @(posedge dsp_clk) - eth_mac_debug <= {// {eth_tx_full2, eth_tx_empty2, eth_tx_occ2[13:0]}, - // {underrun, overrun, debug_mac0[13:0] }, - {debug_txc[15:0]}, - {eth_rx_full2, eth_rx_empty2, eth_rx_occ2[13:0]} }; + eth_mac_debug <= { { GMII_TX_EN, GMII_RX_DV, debug_txc[13:0]}, + {eth_rx_full2, eth_rx_empty2, eth_rx_occ2[13:0]} }; - wire debug_mux; + wire debug_mux; setting_reg #(.my_addr(5)) sr_debug (.clk(wb_clk),.rst(wb_rst),.strobe(set_stb),.addr(set_addr), .in(set_data),.out(debug_mux),.changed()); //assign debug = debug_mux ? host_to_dsp_fifo : dsp_to_host_fifo; //assign debug = debug_mux ? serdes_to_dsp_fifo : dsp_to_serdes_fifo; - // Assign various commonly used debug buses. - /* - wire [31:0] debug_rx_1 = {uart_tx_o,GMII_TX_EN,strobe_rx,overrun,proc_int,buffer_int,timer_int,GMII_RX_DV, - irq[7:0], - GMII_RXD, - GMII_TXD}; + assign debug_clk[0] = wb_clk; + assign debug_clk[1] = dsp_clk; + + assign debug = 0; + assign debug_gpio_0={{8'b0}, + {8'b0}, + {8'b0}, + {1'b0,pps_o,pps_int,epoch,pps_pos_d1,pps_posedge,pps_neg_d1,pps_negedge}}; + assign debug_gpio_1 = 0; - wire [31:0] debug_rx_2 = { 5'd0, s8_we, s8_stb, s8_ack, debug_rx[23:0] }; +endmodule // u2_core + +//assign debug = {{strobe_rx,/*adc_ovf_a*/ 1'b0,adc_a}, +// {run_rx,/*adc_ovf_b*/ 1'b0,adc_b}}; + +//assign debug = debug_tx_dsp; +//assign debug = debug_serdes0; + +//assign debug_gpio_0 = 0; //debug_serdes0; +//assign debug_gpio_1 = 0; //debug_serdes1; + +// assign debug={{3'b0, wb_clk, wb_rst, dsp_rst, por, config_success}, +// {8'b0}, +// {3'b0,ram_loader_ack, ram_loader_stb, ram_loader_we,ram_loader_rst,ram_loader_done }, +// {cpld_start,cpld_mode,cpld_done,cpld_din,cpld_clk,cpld_detached,cpld_misc,cpld_init_b} }; + +//assign debug = {dac_a,dac_b}; + +/* + assign debug = {{ram_loader_done, takeover, 6'd0}, + {1'b0, cpld_start_int, cpld_mode_int, cpld_done_int, sd_clk, sd_csn, sd_miso, sd_mosi}, + {8'd0}, + {cpld_start, cpld_mode, cpld_done, cpld_din, cpld_misc, cpld_detached, cpld_clk, cpld_init_b}}; */ + +/*assign debug = host_to_dsp_fifo; + assign debug_gpio_0 = eth_mac_debug; + assign debug_gpio_1 = 0; + */ +// Assign various commonly used debug buses. +/* + wire [31:0] debug_rx_1 = {uart_tx_o,GMII_TX_EN,strobe_rx,overrun,proc_int,buffer_int,timer_int,GMII_RX_DV, + irq[7:0], + GMII_RXD, + GMII_TXD}; + + wire [31:0] debug_rx_2 = { 5'd0, s8_we, s8_stb, s8_ack, debug_rx[23:0] }; wire [31:0] debug_time = {uart_tx_o, 7'b0, irq[7:0], @@ -741,28 +788,3 @@ module u2_core */ - // Choose actual debug buses - assign debug_clk[0] = wb_clk; - assign debug_clk[1] = dsp_clk; - - //assign debug = {{strobe_rx,/*adc_ovf_a*/ 1'b0,adc_a}, - // {run_rx,/*adc_ovf_b*/ 1'b0,adc_b}}; - - //assign debug = debug_tx_dsp; - //assign debug = debug_serdes0; - - assign debug_gpio_0 = 0; //debug_serdes0; - assign debug_gpio_1 = 0; //debug_serdes1; - -// assign debug={{3'b0, wb_clk, wb_rst, dsp_rst, por, config_success}, - // {8'b0}, - // {3'b0,ram_loader_ack, ram_loader_stb, ram_loader_we,ram_loader_rst,ram_loader_done }, - // {cpld_start,cpld_mode,cpld_done,cpld_din,cpld_clk,cpld_detached,cpld_misc,cpld_init_b} }; - - //assign debug = {dac_a,dac_b}; - - assign debug = {{ram_loader_done, takeover, 6'd0}, - {1'b0, cpld_start_int, cpld_mode_int, cpld_done_int, sd_clk, sd_csn, sd_miso, sd_mosi}, - {8'd0}, - {cpld_start, cpld_mode, cpld_done, cpld_din, cpld_misc, cpld_detached, cpld_clk, cpld_init_b}}; -endmodule // u2_core |