diff options
Diffstat (limited to 'host/docs/usrp_e1xx.rst')
| -rw-r--r-- | host/docs/usrp_e1xx.rst | 16 |
1 files changed, 11 insertions, 5 deletions
diff --git a/host/docs/usrp_e1xx.rst b/host/docs/usrp_e1xx.rst index 2818a0a65..036d2c02c 100644 --- a/host/docs/usrp_e1xx.rst +++ b/host/docs/usrp_e1xx.rst @@ -20,7 +20,6 @@ Example device address string representations to specify non-standard FPGA image Changing the master clock rate ------------------------------------------------------------------------ The master clock rate of the USRP embedded feeds both the FPGA DSP and the codec chip. -UHD can dynamically reconfigure the clock rate though the set_master_clock_rate() API call. Hundreds of rates between 32MHz and 64MHz are available. A few notable rates are: @@ -36,8 +35,12 @@ To use the 61.44MHz clock rate, the USRP embedded will require two jumpers to be * J16 is a two pin header, remove the jumper (or leave it on pin1 only) * J15 is a three pin header, move the jumper to (pin1, pin2) -For the correct clock settings, call usrp->set_master_clock_rate(61.44e6) -before any other parameters are set in your application. +Then run the following commands to record the setting into the EEPROM: +:: + + cd <install-path>/share/uhd/utils + ./usrp_burn_mb_eeprom --key=mcr --val=61.44e6 + ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Set other rates - uses internal VCO @@ -47,8 +50,11 @@ To use other clock rates, the jumpers will need to be in the default position. * J16 is a two pin header, move the jumper to (pin1, pin2) * J15 is a three pin header, move the jumper to (pin2, pin3) -For the correct clock settings, call usrp->set_master_clock_rate(rate) -before any other parameters are set in your application. +Then run the following commands to record the setting into the EEPROM: +:: + + cd <install-path>/share/uhd/utils + ./usrp_burn_mb_eeprom --key=mcr --val=<rate> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Clock rate recovery - unbricking |