1 files changed, 0 insertions, 84 deletions
diff --git a/control_lib/spi.v b/control_lib/spi.v
deleted file mode 100644
index a80c488e9..000000000
--- a/control_lib/spi.v
+++ /dev/null
@@ -1,84 +0,0 @@
-
-
-// AD9510 Register Map (from datasheet Rev. A)
-
-/* INSTRUCTION word format (16 bits)
- * 15       Read = 1, Write = 0
- * 14:13    W1/W0,  Number of bytes 00 - 1, 01 - 2, 10 - 3, 11 - stream
- * 12:0     Address
- */
-
-/* ADDR     Contents             Value (hex)
- * 00       Serial Config Port   10 (def) -- MSB first, SDI/SDO separate
- * 04       A Counter
- * 05-06    B Counter
- * 07-0A    PLL Control
- * 0B-0C    R Divider
- * 0D       PLL Control
- * 34-3A    Fine Delay
- * 3C-3F    LVPECL Outs
- * 40-43    LVDS/CMOS Outs
- * 45       Clock select, power down
- * 48-57    Dividers
- * 58       Func and Sync
- * 5A       Update regs
- */
-
-
-module spi
-  (input reset,
-   input clk,
-
-   // SPI signals
-   output sen, 
-   output sclk,
-   input sdi,
-   output sdo,
-
-   // Interfaces
-   input read_1,
-   input write_1,
-   input [15:0] command_1,
-   input [15:0] wdata_1,
-   output [15:0] rdata_1,
-   output reg done_1,
-   input msb_first_1,
-   input [5:0] command_width_1,
-   input [5:0] data_width_1,
-   input [7:0] clkdiv_1
-   
-   );
-
-   reg [15:0]  command, wdata, rdata;
-   reg 	       done;
-
-   always @(posedge clk)
-     if(reset)
-       done_1 <= #1 1'b0;
-   
-   always @(posedge clk)
-     if(reset)
-       begin
-	  counter <= #1 7'd0;
-	  command <= #1 20'd0;
-       end
-     else if(start)
-       begin
-	  counter <= #1 7'd1;
-	  command <= #1 {read,w,addr_data};
-       end
-     else if( |counter && ~done )
-       begin
-	  counter <= #1 counter + 7'd1;
-	  if(~counter[0])
-	    command <= {command[22:0],1'b0};
-       end
-
-   wire done = (counter == 8'd49);
-   
-   assign sen = (done | counter == 8'd0);  // CSB is high when we're not doing anything
-   assign sclk = ~counter[0];
-   assign sdo = command[23];
-   
-
-endmodule // clock_control