1) u2p has added a new signal from the SRAM to the pinout, RAM_ZZ

which allows the SRAM to be placed in a sleep mode. This pin was
erroniously pulled high at the top level rendering the SRAM unusable.

2) Added declaration for extramfifo debug bus which had got deleted
at some point in the past

3) Created a debug bundle of signals from extsramfifo to help diagnose
problem 1)

4) u2p Rev1 PCB ommits control of any of the SRAM chip selects. Made a
code change so that control logic does not rely on the presence of this
pin and ensuring that the SRAM is always placed in READ mode in any idle cycles.

2 files changed, 5 insertions, 2 deletions

diff --git a/usrp2/top/u2plus/u2plus.v b/usrp2/top/u2plus/u2plus.v
index 5396ae6cd..d4a681731 100644
--- a/usrp2/top/u2plus/u2plus.v
+++ b/usrp2/top/u2plus/u2plus.v
@@ -486,7 +486,8 @@ module u2plus
 		     .spiflash_mosi     (flash_mosi)
 		     );
 
-   assign RAM_ZZ = 1;
+   // Drive low so that RAM does not sleep.
+   assign RAM_ZZ = 0;
    // Byte Writes are qualified by the global write enable
    // Always do 36bit operations to extram.
    assign RAM_BWn = 4'b0000;
diff --git a/usrp2/top/u2plus/u2plus_core.v b/usrp2/top/u2plus/u2plus_core.v
index 9b177390a..081ffe4c6 100644
--- a/usrp2/top/u2plus/u2plus_core.v
+++ b/usrp2/top/u2plus/u2plus_core.v
@@ -164,7 +164,9 @@ module u2plus_core
    wire [31:0] 	atr_lines;
 
    wire [31:0] 	debug_rx, debug_mac, debug_mac0, debug_mac1, debug_tx_dsp, debug_txc,
-		debug_serdes0, debug_serdes1, debug_serdes2, debug_rx_dsp, debug_udp;
+		debug_serdes0, debug_serdes1, debug_serdes2, debug_rx_dsp, debug_udp,
+		debug_extfifo;
+   
 
    wire [15:0] 	ser_rx_occ, ser_tx_occ, dsp_rx_occ, dsp_tx_occ, eth_rx_occ, eth_tx_occ, eth_rx_occ2;
    wire 	ser_rx_full, ser_tx_full, dsp_rx_full, dsp_tx_full, eth_rx_full, eth_tx_full, eth_rx_full2;