Merge branch 'udp' into master_merge_take2

* udp: (67 commits)
  better test program for just the tx side
  fix typo, no functionality difference
  ignores
  move dsp settings regs to reclocked setting bus.  Works, gets us to within 18ps of passing timing
  reverting logic clean up which should have made timing better, but made it worse instead
  moved fifos around, now easier to see where they are and how big
  bigger fifo on UDP TX path, to possibly fix overruns on decim=4
  Xilinx ISE is incorrectly parsing the verilog case statement, this is a workaround
  pps and vita time debug pins
  ignore emacs backup files
  more debug for fixing E's
  better debug pins for going after cascading E's
  copy in wrong place
  copied over from quad radio
  just debug pin changes
  typo caused the tx udp chain to be disconnected
  moved into subdir
  speed up timing by ignoring the too_early error.  We'll need to FIXME this later
  Added set time and set time at next pps. Removed the old sync pps commands, they dont make sense to use anymore.
  moved around regs, added a bit to allow for alternate PPS source
  ...

1 files changed, 5 insertions, 6 deletions

diff --git a/usrp2/sdr_lib/dsp_core_tx.v b/usrp2/sdr_lib/dsp_core_tx.v
index 346d65ced..22d3d44a3 100644
--- a/usrp2/sdr_lib/dsp_core_tx.v
+++ b/usrp2/sdr_lib/dsp_core_tx.v
@@ -1,7 +1,6 @@
 
-`define DSP_CORE_TX_BASE 128
-
 module dsp_core_tx
+  #(parameter BASE=0)
   (input clk, input rst,
    input set_stb, input [7:0] set_addr, input [31:0] set_data,
 
@@ -22,19 +21,19 @@ module dsp_core_tx
    wire [3:0]  dacmux_a, dacmux_b;
    wire        enable_hb1, enable_hb2;
 
-   setting_reg #(.my_addr(`DSP_CORE_TX_BASE+0)) sr_0
+   setting_reg #(.my_addr(BASE+0)) sr_0
      (.clk(clk),.rst(rst),.strobe(set_stb),.addr(set_addr),
       .in(set_data),.out(phase_inc),.changed());
 
-   setting_reg #(.my_addr(`DSP_CORE_TX_BASE+1)) sr_1
+   setting_reg #(.my_addr(BASE+1)) sr_1
      (.clk(clk),.rst(rst),.strobe(set_stb),.addr(set_addr),
       .in(set_data),.out({scale_i,scale_q}),.changed());
    
-   setting_reg #(.my_addr(`DSP_CORE_TX_BASE+2)) sr_2
+   setting_reg #(.my_addr(BASE+2)) sr_2
      (.clk(clk),.rst(rst),.strobe(set_stb),.addr(set_addr),
       .in(set_data),.out({enable_hb1, enable_hb2, interp_rate}),.changed());
 
-   setting_reg #(.my_addr(`DSP_CORE_TX_BASE+4)) sr_4
+   setting_reg #(.my_addr(BASE+4)) sr_4
      (.clk(clk),.rst(rst),.strobe(set_stb),.addr(set_addr),
       .in(set_data),.out({dacmux_b,dacmux_a}),.changed());